Every Blue Card … General Industry 10 and 30 Hour Course Differences. First, when a miner has an STS, the MSHA standard requires the mine operator to review the effectiveness of engineering and administrative noise controls, and to correct any deficiencies. But there is also less reportable MSHA hearing loss compared to OSHA due the criterion being a 25 dB average change instead of a 10 dB average change. First, MSHA is required by law to visit mines two times each year (Surface, Metal/Nonmetal) and Coal mines/underground mines 4 times each year. OSHA and MSHA, sister agencies within the Department of Labor, inked a memorandum of understanding (MOU) in 1979 that set limits on their areas of authority. Age correction is allowed in order to not penalize the employer for hearing loss associated with aging. Blue Card trainers must pass a very difficult test to become certified MSHA trainers. Going Back to Work? Before and after these meetings, we often field questions on the difference between ANSI and OSHA. These differences in philosophy between MSHA, OSHA, and the DMV seem to mirror the differences between individual people. Age correction is allowed in the calculation. Your email address will not be published. MSHA, like OSHA, is part of the US Department of Labor. OSHA’s HCS and other OSHA standards : More than one miner may use an unlabeled temporary, portable container Only one employee who transferred the chemical from a labeled container can use OSHA and Workplace Safety MSHA and Mine Safety. The table permits a quick comparison of the hearing conservation requirements of US general industry (OSHA, 1983), mining (MSHA, 1999), and the most recent recommendations of NIOSH (1998). A standard is promulgated under § 101 of the Mine Safety and Health Act of 1977 (Mine Act) (30 U.S.C. For OSHA purposes, the baseline may be the original baseline, a baseline revised for improved hearing, or a baseline revised for persistently worse hearing. Mining & Tunneling. The STS is calculated exactly the same for MSHA as it is for OSHA, but MSHA does not consider the STS a reportable hearing loss. Second, MSHA’s annually required hearing conservation training incorporates miner training in the maintenance of noise controls – no such employee noise control training is required by OSHA. MSHA functions much the same way OSHA does but there are several notable exceptions. Work performed on mine properties is governed by the Mine Safety and Health Administration (MSHA). 957) and includes MSHA approval requirements, petition for modification The website cannot function properly without these cookies, and can only be disabled by changing your browser preferences. Mind reading doesn’t work. A blog focused on OSHA and MSHA compliance in the workplace. The ANSI Z359 suite of standards addresses just about all forms of fall protection equipment (harnesses, carabiners, lanyards, fall arrestors, etc) and associated work practices (rope access, rescue, management of fall protection programs, etc). Importantly, the current test is always compared to the original baseline unless that baseline has been revised for improvement (this does not often happen). Administered by the Mine Safety and Health Administration (MSHA), the Act affects miners and mine operators who work on mine property within the United States. The laws and regulations of each agency are different. Mining safety is governed by the Federal Agency Mine Safety and Health Administration. Gravity, you and fall protection. This is exactly the same calculation as the STS, but with a criterion of 25 dB HL instead of 10 dB HL. Please note following conditions for use of this table. OSHA will work to facilitate referrals of potential violations of EPA regulations to EPA and will encourage the relevant State agencies in those States which operate their own occupational safety and health programs (under a plan approved by OSHA under Section 18 … Exposures in excess of the PEL require engineering and/or administrative noise control as well as hearing protection.
2020 osha and msha differences